Results 1 to 3 of 3

Thread: How to enable PC supply as 12V DC power source?

  1. #1

    Default How to enable PC supply as 12V DC power source?

    I have unlabelled PC supply - about 3 x3 x10 inches - with standard Molex plugs and 2x10 connector.
    I have read somewhere that to use PC power supply it has to be "enabled" by hardware connection.

    Could somebody give me a hint what to ask Mrs Google ?

    I need 12V DC supply for NOT powering amateur equipment.

    PS I believe the 2x10 plug has standard PC designation - such as J xxx.

  2. #2
    gnuuser's Avatar
    Join Date
    Apr 2020
    Location
    NW Pa,USA
    Posts
    158

    Default

    a pc power supply is a switching power supply and can often make a lot of unwanted electrical noise in radio equipment.
    If I remember correctly
    what needs to be done with an atx supply is to locate the power good wire and add a switch to it to ground, this will turn the power supply on!

    one of the 5 volt positive wires needs a 5 ohm 5 watt wire=wound resister to ground.
    and last there is a couple small pots on the board you may have to adjust to either raise the voltage to 13.5 volts or 12.8 volts
    there are various videos on you-tube on how to do this.

    a 400 watt supply producing 12 volts will provide 33 amps of current

    an at power supply however does not have a power good circuit, but you need the switch from the case taking care to reconnect the wires exactly as they were or risk burning the supply up. these type supplies were in win 95/98 era and earlier.
    yellow wire was 12 v+ black was ground, red was 5 volt +
    in atx orange wire was 3 v+
    Last edited by gnuuser; Mon 23rd Nov 2020 at 00:13.
    Im so old dirt was my apprentice

  3. #3

    Join Date
    Jan 2021
    Location
    North of Atl, GA
    Posts
    1

    Default ATX Power Supply to Benchtop Power Supply

    I don't know if you've found what you're looking for yet or not but try doing a search for "ATX Power Supply to Benchtop Power Supply". There's also a decent post on the Dronebot Workshop on Youtube.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •